Crochet Bunny EOS Cover

Whip up this cute crochet bunny eos cover. I quick and easy crochet project that takes less than an hour. These would make cute favors for anyone that is a fan of eos lip balm. Wouldn’t these be cute sitting on plates at Easter dinner or just for fun at a ladies brunch? This easy project is a great way to use up leftover bits of yarn. Another stash busting project is these mini crochet baskets. Too cute! If you love gifting eos check out all of these eos printables. They make super last minute gifts!

Crochet Bunny EOS Cover Supplies

Worsted weight yarn
H (5.00mm) hook
G (4.25mm) hook
stitch marker
Small pom Pom for tail, and
embroidery thread for face
embroidery needle
tapestry needle
Hot glue gun for tail or sewing needle and thread to attach

Crochet Bunny EOS Cover Pattern

Ch: chain

Sl st: slip stitch

sc: single crochet

HDC: half double crochet

st mk: stitch marker

With H (5.00mm) hook Ch 4, join with sl st in 1st ch to create a circle, then ch 1. Place st mk and work 6 sc in circle.

Join with sl st in ch 1 with the st mk. (You can pull the shorter tail of yarn to tighten the loop).

Rnd 2: Ch 1, place st mk. 2 sc in each of the 6 sts in the round (12 sts). Join with sl st in ch 1 with st mk.

Rnd 3: Ch 1, place st mk. 1 Sc in next st *2sc in next st, then 1 sc in next st* repeat steps between * until the second to last st. Work 2

Sc in the last st (18 sts). Join with sl st in chain 1 with st mk.

Rnd 4: ch 1, place st mk. 1 sc in each st in the round (18 sts) sl st into ch 1.

Rnd 5: ch 1, place st mk. 1 sc in each st in the round (18 sts) sl st into ch 1.

Rnd 6: ch 1, place st mk. *1 sc in the next 5 sts, 2 sc in the next st* repeat steps between * There will be 3 increases in this round (21sts). Join with sl st in ch 1. when making the sl st at the very end of row 6 switch hook to a G(4.25mm).

Rnd 7-10: ch 1, place st mk. 1 sc in each st in the round (18 sts). Join with sl st in ch 1. Finish off leaving a tail to weave in.

EARS (make 2): Ch 5, 1 HDC in 2nd st from hook. Work 1 HDC in the next 2 sts. Last st in ch work 3 HDC.

Now working on the other side of the ch, work 1 HDC in the next 3 sts (only picking up 1 loop of each st). Place a sl st in the end and finish off leaving a long tail (this is the bottom of the ear). Attach the ear to the cover. Weave in any remaining yarn.

Take your embroidery thread and create a face, then glue or sew Pom Pom tail by hand to finish the Bunny EOS cover.